How to Repair and Replace a Suspended Ceiling?
A suspended ceiling is a false decorated ceiling with a space between it and the mortar floor above it hangs. So often, a suspended ceiling requires repairing, and even if you want to replace it, you need to visit suspended ceiling repair in Perth. There are specific steps that one needs to follow before repairing or replacing a suspended ceiling.
Remove the Suspended Ceiling
For replacing a suspended ceiling, one needs to place a ladder under the o false ceiling board to remove it. Removing a false ceiling is not very hard. It can be done by pressing the hanging ceiling upwards to ease it from the frame. Then, the ceiling board, which is usually made up of a pitch board, should be pulled down from the frame. One needs to be careful with the electric wires while removing the ceilings.
Unwrap the Wires
After removing the suspended ceilings, it is necessary to unwrap the electric wires. Next, it is essential to unclip the ends of the main beams from the wall molding, and then one needs to pull down each of the main beams. Finally, for safety, it is necessary to disconnect all the wall moldings from the walls.
Measurement
One needs to measure the entire room from floor to ceiling height to know the exact area of the suspended ceiling required for the room. It is crucial to measure the angle correctly to cut the pitch board at proper angles for the room’s ceiling. Many people prefer designs for the false ceiling, so they should choose this design while the room’s measurement continues.
Install the Ceiling
Suppose the suspended ceiling is made up of acoustic tiles. In that case, it is easier to repair as the tiles are available on the market.
However, if it is made up of pitch board tiles, one can design by cutting it according to their wish.
Install Metal Bracket
This step needs to be followed by installing a metal wall bracket into the wall. Again, it is vital to add all the metal brackets similar to the wall. After that, a wire of 18 inches is required. This 18-inch wire needs to be slipped through one anchor on a joist from the early installation. This step needs to be followed by wrapping a 6-inch wire tail to allow the suspended ceiling to hang.
Connect T-bar
It is necessary to connect the wires to the T-bar until one comes to the bar’s edge. Add T-bars according to the requirements to complete the first run. After that, clip-on T-bar sections are needed to do until the grid is complete.
Install Ceiling
After completing the entire process, you can now hang the false ceiling to complete the room’s decoration. Tilt each ceiling tile according to the condition of the ceiling so that the tiles can fit into the grid, then allow it to rest on the mains and T’s. If the shape is not fitting, then cut tiles using a sharp knife to cut out the extra portion.
If you think the entire process is complicated, you must have a local suspended ceiling repair and replacement shop like drop ceiling repair in Wanneroo. Installing a suspended ceiling is trending in the market because modern houses design goes with the suspended ceiling design. Even if your house is old and you want to renovate, then installing a suspended ceiling is a good option as it gives a new look to your old house.
Author’s Bio
The author is an expert at a suspended ceiling repair in Perth and writes blogs about drop ceiling repair in Wanneroo.
